ABS Filament - Bambu Studio

Introduction

This is a comprehensive materials settings guide to help get started!

The settings listed below have been found to produce the best results using Bambu Labs X1C in our test lab. However, every printer is unique and different, and settings need to be tweaked based on the hardware. Consider these parameters as a solid starting point rather than rigid, foolproof configurations. You can always reach out to us at info@numakers.com if you have any questions. 

Drying recommendation 

Temp (°C)

80

Time (h)

4-6

Instructions

Advanced settings enabled. Load the generic ASA profile and make the following modifications. 

 

Settings

Basic information 

Type

ABS

Flow ratio

0.95

Recommended nozzle temperature

240-280

Print temperature

Nozzle (first layer/other layers)

260/265

Cool plate / PLA plate  (first layer/other layers)

0/0

Engineering plate (first layer/other layers)

90/90

High temp plate (first layer/other layers)

90/90

Textured PEI plate   (first layer/other layers)

90/90

Volumetric speed limitation 

Max volumetric speed

22

Cooling for specific layer

No cooling for the first 

3

Part cooling fan 

Min fan speed threshold 

10%, 30s

Max fan speed threshold 

80%, 3s

Keep fan always on

Yes 

Slow printing down for better layer cooling 

Yes 

Min print speed

20 

Force cooling for overhangs and bridges 

Yes 

Cooling overhang threshold 

25 

Fan speed for overhangs  

80 

Auxiliary part cooling fan  

Fan speed

0

Retraction 

Retraction 

Default generic ABS settings

Recommended printer upgrades

Special Nozzle

None

Bed adhesion

PEI, Glass Plate, Painter's tape, Glue stick

Heated bed

Required

Enclosure

Required