PLA Plus - Bambu Studio
Introduction
This is a comprehensive materials settings guide to help get started!
The settings listed below have been found to produce the best results using Bambu Labs X1C in our test lab. However, every printer is unique and different, and settings need to be tweaked based on the hardware. Consider these parameters as a solid starting point rather than rigid, foolproof configurations. You can always reach out to us at info@numakers.com if you have any questions.
Drying recommendation
Temp (°C) |
55 |
Time (h) |
2-4 |
Instructions
Advanced settings enabled. Load the generic PLA profile and make the following modifications.
Settings
Basic information
Type |
PLA |
Flow ratio |
1.0227 |
Recommended nozzle temperature |
225-255 |
Print temperature
Nozzle (first layer/other layers) |
230/230 |
Nozzle (first layer/other layers) for shiny finish |
230/250 |
Cool plate / PLA plate (first layer/other layers) |
35/35 |
High temp plate (first layer/other layers) |
55/55 |
Textured PEI plate |
55/55 |
Volumetric speed limitation
Max volumetric speed |
15 |
Cooling for specific layer
No cooling for the first |
1 |
Part cooling fan
Min fan speed threshold |
100%, 100s |
Max fan speed threshold |
100%, 8s |
Keep fan always on |
Yes |
Slow printing down for better layer cooling |
Yes |
Min print speed |
20 |
Force cooling for overhangs and bridges |
Yes |
Cooling overhang threshold |
50 |
Fan speed for overhangs |
100 |
Auxiliary part cooling fan
Fan speed |
70 |
Retraction
Retraction |
Default PLA settings |
Recommended printer upgrades
Special Nozzle |
None |
Bed adhesion |
PEI, Glass Plate, Painter's tape, Glue stick |
Heated bed |
Recommended |
Enclosure |
Not required |